NetModule NB3700 - Page 163

NB3700 User Manual 3.8
Usage :
set [− hv ] <parameter>=<value> [<parameter>=<value > . . ]
Options :
−v validate config parameter
6.5. Getting Status Information
The status command can be used to get various status information of the system.
> status −h
Usage :
status [− hs ] <section>
Options :
−s generate sourceable output
Available sections :
summary Short status summary
info System and config information
config Current configuration
system System information
configuration Configuration information
license License information
wwan WWAN module status
wlan WLAN module status
gnss GNSS ( GPS ) module status
eth Ethernet interface status
lan LAN interface status
wan WAN interface status
openvpn OpenVPN connection status
ipsec IPsec connection status
pptp PPTP connection status
gre GRE connection status
dialin Dial−In connection status
mobileip MobileIP status
dio Digital IO status
audio Audio module status
can CAN module status
uart UART module status
ibis IBIS module status
redundancy Redundancy status
163