To identify codes by displaying the
related reader IDs in a situation that
a base communicates with many
readers simultaneously.
To construct a “many to one” network.
1) scan the code “enter setting” on the top of page
9.
2) scan the code “display transmitter ID” on page
9, the reader will emit beeps.
3) put the reader close to the base and unplug the
base for a few seconds and then plug back. The
flashing light and the beeper will stop.
4) scan the last code on page 9 “save & exit”.
There will be an ID number of this reader “10”
displayed before this reader’s every scanned
code. (Defaulted: 10)
To change the ID to other number, like “200”
(range: 1-254)
1) scan the code “enter setting” on the top of page
8.
2) scan the code “set transmitter ID” on page 8.
3) scan the numbers codes on page 11, “2”, “0”,
“0” and end with “#”.
4) scan the code on page 8 “save & exit”.
To configure different working
channels for scanner sets to
communicate simultaneously
in a network and avoid data
interference on hosts. E.g.:
channel=6. (Defaulted= 10)
Make sure that the base is connected to the host
with antenna.
Set transmitter channel.
1) scan the code “enter setting” on page 8.
2) scan the code “set transmitter channel” on page
8.
3) scan the number code “6” on page 11 and end
with “#”.
4) scan the code “save & exit” on page 8 to finish
transmitter channel setting.
Set receiver channel.
5) scan the code “enter setting” on page 9.
6) scan the code “set receiver channel” on page 9.
Further operating the scanner (continued)
7) scan the number code “6” on page 11
and end with “#”. (The number should be
the same as setting transmitter channel.)
The base will emit beeps.
To Next Page
Loading...
Need help?
General
