Networker TS790 - Part-Setting With Part Set Passcodes (Cont.)

To Next Page

To Previous Page

Part-Set ting With Part S et Passcodes (Cont.)

To unset your area(s), proceed as follows:

1. Enter the area or premises via the

prescribed entryrouteandproceed directly

totheremotekeypad.Theinternalsounders

generate an interrupted tone. The display

willshowhowmuchtimeyouhavelefte.g.,

2. Enter your “Code Set Group” passcode

? ? ? ? within the entry time. The

internal sounders will stop and the display

will show the wards that have remained set

and the time, e.g.,

The system may be returned to the full set condition by re-entering the “Code Set Group”

passcode and leaving the area or premises via the prescribed exit route. The system may also

be fully unset at any time by entering a valid passcode (Master, Standard or Holiday).

Code Set Group A: Sets/unsets wards S: o A: o B: o C: o

Code Set Group B: Sets/unsets wards S: o A: o B: o C: o

Code Set Group C: Sets/unsets wards S: o A: o B: o C: o

Full Set Group: Sets/unsets wards S: o A: o B: o C: o

TS790 & TS90 0 User Manual Operating The System

Wards set [S C]

09:30 Sun 28 APR

PART SET

SET

S C

09.30

Enter Your Code

Time left > 0025

LCD

0025

Starburst

0025

LED

Other manuals for Networker TS790