Networker TS790 - Full Setting The System

Ful l Settin g The System
The full setting procedure may be initiated from any remote keypad (if more than one is fitted).
Before attempting to full set the alarm system ensure that all movement detectors are
unobstructed and all doors, and windows are secure.
Theinstallationcompanywillhaveset-upyouralarmsystemtofullsetbyoneofthefollowing:
Timed E xit
-
After entering your passcode the alarm system will be full set after the
pre-programmed exit timer has expired. The display at step (2) will
count down the remaining exit time.
Final Exit
-
After entering your passcode the alarm system will be full set after the
Final Exit door is opened and closed. The display at step (2) will show a
count of 9999.
Exit Terminator
-
After entering your passcode the alarm system will be full set after the
Final Exit door is opened and closed, and after pressing the Exit
Terminator button (a push button normally mounted outside of the
premises). The display at step (2) will show a count of 9999.
Instant
-
After entering your passcode the alarm system will be full set after 5
seconds.
+
If an attempt is made to full set the system whilst any circuits are active (such as a door
being open) the display at step (2) will indicate the circuit(s) that are in fault and internal
sounder generates an interrupted tone. The fault must be cleared before the setting
procedure can be completed. If the system is setby "Timed Exit"or "Instant", and the fault
is still present at the end of the exit time an internal alarm will be generated. If fitted, the
external strobe light will flash indicating that the system has “Failed to set”. To prevent this
alarm simply re-enter your passcode before the exit timer expires.
» To fu ll set the s ystem proceed as follows:
1. Enter your passcode ? ? ? ?. The
display will show:
2. After 5 seconds the exit sounder will start
and the display will show:
3. Leave via the prescribed exit route.
4. The system is set when the exit time has
expired, on activation of the Final Exit circuit
or pressing the Exit Terminator button, as
appropriate. The exit sounder will stop and
the display will show:
5. After 5 seconds the “SYSTEM SET”
message will disappear and the display will
show the time, (date and banner text, LCD
only) e.g.,
Setting Mode: Timed o Final Exit o Exit Terminator o Instant o
Exit Time: ________________________
5
TS790 & TS90 0 User Manual Operating The System
Press ENT to
Select Functions
LCD
FUNCTION
Starburst
Func
.
LED
Please Exit Now.
Time left > 9999
9999
9999
SYSTEM SET
05:30 Sun 28 APR
SET
SET
ABC SECURITY
05:30 Sun 28 APR
05:30
05
.
30