To Next PageTo Next Page
Need help?Do you have a question about the Networker TS790 and is the answer not in the manual?
General| Display | 7-inch TFT LCD |
|---|---|
| Resolution | 800 x 480 |
| Processor | ARM Cortex-A8 |
| Connectivity | Ethernet |
| Weight | 500g |
Details procedures for setting the alarm system, including different exit modes.
Explains how to unset the alarm system, including entry procedures.
Describes how to part-set the alarm using dedicated buttons (A, B, C).
Explains setting and unsetting areas using specific passcodes for part-set groups.
Continues the explanation of setting/unsetting areas with part-set passcodes.
Details how to set the alarm system silently (full or part-set).
Describes how to unset the system after an alarm has occurred.
Details the procedure for an engineer to reset the alarm system.
How standard users can select specific wards to set.
How standard users can unset specific wards.
Procedure for setting additional wards beyond the initial part-set.
Using specific passcodes to set/unset wards within defined groups.
Explains the different reset procedures (User, Engineer, Remote) after an alarm.
Explains the remote reset procedure using a seed code.
Details how to assign user types and passcodes for up to 31 users.
Details how to assign circuits to wards and select/de-select wards.
Manages user passcodes, types (Master, Standard, Holiday, etc.).
Allows the system to be split into four wards (S, A, B, C) for flexible setting.
Explains selecting/deselecting wards for each part-set group.
Details how code set groups are programmed and their operation.
Defines how part-set buttons (A, B, C) trigger specific ward combinations.
Defines passcode types for setting/unsetting specific ward combinations.
Lists and explains common alarm and status messages displayed by the system.
Continues the list and explanation of system display messages.
