Setup Users (Cont.)
To setup users proceed as follows:
1. Ensure that “User menu 2" is selected.
Press 4 to select the Setup users option.
The display will show:
2. Enter the user number (02-31) that is
required to be setup, e.g., to setup user 12
enter "12" followed by [. The display will
show the current user type (Note: If the
codeis currently unassigned,thedisplaywill
show "Not in use":
3. Select a new user type by pressing:
1 Master 7 PA Code
2 Standard 8 Access
3 Holiday 9 Full set group
4 Set Only A Code set grp A
5 Reset Only B Code set grp B
6 Duress C Code set grp C
e.g., to select user type "Standard"
press "2". The display will show:
4. When the display shows the required
usertypepress[ toaccept.The displaywill
show:
5. Entera 4 digitpasscode for the selected
user, e.g., enter "2580". The display will
show:
6. Press [ to update with new passcode,
a multi-tone will indicate that the passcode
has been accepted and the display will
returntostep1.Alow toneindicatesthatthe
passcodeis notavailable.Re-enter,tryinga
different 4 digit passcode.
7. Repeat from step 1 for other users or
press ] to return to "User menu 2".
+
To delete user passcodes 02-31 from the system, select the user number you wish to
delete at step 2, then enter your own passcode at step 5.
27
TS790 & TS90 0 User Manual User Menu 2
Alter user type
Not in use
NOT USED
NoTU
Setup users
User No. > --
LCD
USER --
Starburst
Ur--
LED
Alter user type
Standard
STANDARD
TYP
.
2
Change pass code
New code > ----
-- --
----
Change pass code
New code > 2580
2580
2580
To Next Page
Loading...
