Networker TS790 - To Set further Wards (assuming ward A is set)

»
To Set further Wards (assuming ward A is set)
1. To set other wards enter your passcode
? ? ? ?. The display will show:
2. Deselect all wards so that the display
shows:
3. Press [ and the display will show:
NOTE: Ward A is not displayed as it is
already set.
4. Select the ward(s) you require to set,
e.g., to set wards B and C, press 0 to
deselect ward S. The display will show:
5. When the display shows the required
wards, press [. The exit sounder will start, if
required leave via the prescribed exit route.
Thedisplaywillshowtheremainingexittime:
6. When the system has set the display will
show the wards that are set and the time:
+
If the system is part-set, entry of a valid passcode is assumed to unset rather than set
further wards. To set further wards, it is necessary to unset nothing, the system will then
assume that you require to set further wards.
15
TS790 & TS90 0 User Manual Operating The System
Please Confirm
Unset -: * A * *
LCD
-A--
Starburst
-A--
LED
Please Confirm
Unset -: * * * *
-- --
----
Please Confirm
Set -: S * B C
S-BC
S-BC
Please Confirm
Set -: * * B C
-- BC
--BC
Please Exit Now.
Time left > 0025
0025
0025
Wards set [ ABC]
06:00 Sun 28 APR
PART SET
P
.
SET
ABC
ABC
06.00
06
.
00