Neutronics 7100E - Appendix C: Analyzer Factory Configuration Settings

Model 7100E Appendix D
Manual P/N: C5-06-4900-14-0
Revision A, dated 24-Jun-2016
55
6.3 APPENDIX C – Analyzer factory configuration settings
Alarm and Relay Setup Information
Alarm-1/Alarm-2 relays fail-safe/non-fail-safe
non-failsafe
Alarm-1/Alarm-2 relay ascending/descending
Ascending
Alarm-1 trigger level
50 PPM
Alarm-2 trigger level
100 PPM
Display Range Analog Voltage Output
0–10 PPM Fixed
0–1 VDC
X
0–100 PPM Fixed
0–5 VDC
0–1,000 PPM Fixed
0–10 VDC
0–2,000 PPM Fixed
Auto Ranging
RS-232 Baud Rate Relay Disable after Cal/Setup
300 BPS
120-seconds
X
1200 BPS
Assume Low End Calibration Range
2400 BPS
4800 BPS
Single Point Calibration
9600 BPS
X
0–5 PPM
19200 BPS
10–50 PPM
X
38400 BPS
10–500 PPM
RS-232 Timed Output Format (Select One)
Output on Request Only
Human Readable Format
X
Machine Code
Machine Code With Checksum
Tab Delimited (Spreadsheet)
Supply Voltage RS-232 Dump Rate
90 – 264 VAC, 47 – 63 Hz
X
1-second
X
11 – 18 VDC
20 – 30 VDC