Manual Part Number:
5-06-7000-65-0
Manual File:
MN-A-0117 Rev. D
Revision Date: August 24, 2006 Page 3-9
Press the “FEED” button shown in Figure 30 to automatically advance the paper through the
printer. When the paper appears on the top of the printer, press the “STOP button. Press the
“TEST” button to print a test message and verify that the paper is installed properly. Slide the
paper through the slot in the printer door and close the door.
3.6 Low Battery Warning
For units equipped with the optional rechargeable battery, a “Low Battery Warning” will appear
when the battery is nearly exhausted. Several tests may be run after the initial warning however,
it is strongly recommended that the unit be recharged or the external battery clips be used.
3.7 Error Messages
In the unlikely event that an “Error” message is displayed on the screen, power off the unit, take it
to a location outside of the shop environment where fresh air is available and turn the unit back
on. If the “Error” message reappears, contact our service department for assistance.
Neutronics Inc.
456 Creamery Way
Exton, PA 19341
Ph: 800-378-2287 x 123 or 610-524-8800 x 123
Fax: 610-524-8807
To Next Page
Loading...
Need help?
General
