Contents
Newall Measurement Systems
1
ONTENTS
1.0 Introduction
1.1 EMC and Low Voltage Compliance
1.2 Technical Specifications
2.0 Installation
2.1 Mounting
2.2 Power Supply
2.3 Connections
2.4 Switching On
3.0 User Instructions
3.1 Options
3.2 Using the Keypad
4.0 Set-Up
4.1 Set-Up Introduction
4.2 Set-Up Defaults
4.3 Set-Up Menu
5.0 Standard Functions
5.1 Absolute/Incremental
5.1.1 Using Incremental
5.1.2 Using Absolute
5.1.3 Establishing a datum
5.2 Centre Find
5.3 Digifind (Ref)
5.3.1 Using a machine marker or
workpiece marker
5.3.2 Find Absolute Zero
5.4 Sub Datums (SDM)
5.4.1 Method 1 (Teach mode)
5.4.2 Method 2 (Manual Mode)
5.4.3 Job Number
5.4.4 Editing Sub Datums and Job Number
5.5 Inch/mm
5.6 Datahold (Display Off)
5.7 Zero Approach
6.0 Mill Functions
6.1 Arc
6.2 PCD (Bolt Hole Circle)
6.3 Line Hole
6.4 Polar Co-ordinates
7.0 Lathe Functions
7.1 Tool Offsets
7.2 Taper
7.3 Summing
7.4 Vectoring
8.0 Auxiliary Output Option
8.1 Position Pulse Output
8.2 Remote Zero and Enter Inputs
9.0 Troubleshooting
10.0 Cleaning
CONTENTS
To Next Page
Loading...