Newall DP8 - Editing Sub Datums and Job Number

Standard Functions
Newall Measurement Systems
25
JOB NO?
ent
Enter the required job
number. Confirm with Enter
JOB 1234
The Sub Datums are searched to find the Job Number.
If the number is not found the first number will be displayed.
3
4
2
1
Pressing [ ABS/INC ] at any time will exit the function.
ent
>
Alternatively, the right arrow key will display
all the available job numbers.
Pressing the (ENT) key will make the
selected job number active.
5.4.4 Editing Sub Datums and Job Numbers
To edit the Sub Datums and Job Numbers the [ INS ] and [ DEL ] keys are used. From a selected Sub
Datum proceed as follows:
(a) To delete a Sub Datum
SDM 20
As an example, select the Sub Datum to be deleted
eg. SDM 20
DEL SDM?
Pressing the ( DEL) key causes the mes-
sage screen to ask for confirmation if the
Sub Datum is to be deleted.
Pressing the (ENT) key confirms the dele-
tion.
NOTE: Pressing CE clears the selection,
and the SDM is retained.
ent
del.
ce
(b) To delete a Job Number
Follow the above sequence except scroll the message screen, using the arrow keys, to display the Job
Number to be deleted instead of the Sub Datum number.
SDM NO?
sdm
ent
2
0
20
abs
inc
1234?
All the higher numbered Sub-Datums are shifted down one
place. i.e. The Sub Datum figures from SDM21 becomes
the new SDM20, SDM22 becomes SDM21 etc.