Newport Electronics INFCP-B Series User Manual

43
Configuring The Meter
4
43
4.14 USING LOCK OUT CONFIGURATION LK.CF
Refer to Table 6-1 for a summary list of menu configuration.
Use Lock Out Configuration LK.CF for the following:
• To enable or disable setpoint changes
• To enable or disable the RESET button in the Run Mode
• To enable or disable displaying the meter’s firmware version.
4.14.1 Enabling or Disabling the RESET button in the Run Mode
1. Press the MENU button until the meter shows LK.CF (after OT.S.O ).
2. Press the ∂TARE button. The meter shows one of the following:
• RS.=E To enable the RESET button in the Run Mode (Default)
• RS.=D To disable the RESET button in the Run Mode
3. Press the ßMAX button to toggle between available choices.
4. Press the MENU button to store the changes. The meter shows STRD if the new
value is different otherwise the meter shows BRIT and returns to the Run Mode.
4.14.2 Enabling or Disabling SETPOINT Changes
1. Press the MENU button until the meter shows LK.CF (after OT.S.O ).
2. Press the ∂TARE button twice. The meter shows one of the following:
• SP.=E To enable setpoint changes (Default)
• SP.=D To disable setpoint changes
3. Press the ßMAX button to toggle between available choices.
4. Press the MENU button to store the changes. The meter shows STRD if the new
value is different otherwise the meter shows BRIT and returns to the Run Mode.
Note
☞
Downloaded from Elcodis.com electronic components distributor

Newport Electronics INFCP-B Series Specifications

General

Brand	Newport Electronics
Model	INFCP-B Series
Category	Measuring Instruments
Language	English