Chapter 9 Error Messages 95
Error
Code
Explanation
on and the sensitivity set to zero to start.
E-521
Modulation select change shutdown laser outputs (MOPA
only)
E-531
Laser link condition forced output on
E-532
Laser link condition forced output off
E-533
Attempted to select non-laser channel for laser operation.
E-900
Calculation Error shutdown output
E-901
System over temperature shutdown all outputs
E-902
Front laser enable panel key lock in off position,
shutdown all laser outputs
E-903
Loading of a saved bin shutdown module output
To Next Page
Loading...
