8 Chapter 2 System Operation
2.2.2 Tilt-Foot Adjustment
The 8000 has front legs that extend to make it easier to view the LED displays. To
use them, place the 8000 on a stable base and rotate the legs downward until they
lock into position.
2.2.3 Rack Mounting
The 8000 may be rack mounted by using a 8000 rack mount kit. All rack mount
accessory kits contain detailed mounting instructions.
2.2.4 Ventilation Requirements
Rear panel area needs 2 to 4 inches of clearance for air circulation.
2.2.5 Power-Up Sequence
With the 8000 connected to an AC power source, set the power switch to “
I
” or ON
to supply power to the instrument and start the power-up sequence.
During the power-up sequence, the following takes place. For between 15 to 20
seconds an initialization screen is displayed. The software version is displayed in the
lower left corner of the screen. During this time a self-test is performed to ensure that
the 8000 hardware and software are communicating. If the 8000 cannot successfully
complete this test, an error message will be displayed.
After this test, the 8000 is configured to the state it was in when the power was last
shut off and displays the master display.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
