Chapter 9 Specifications 109
9.3 Mainframe And General Specifications
Display
Type LCD graphics display, 240 (W) x 128 (H) pixels
Back Lighting Green LED
Controls Brightness and Contrast (contrast optimizes viewing angle)
Channel Active Green LASER ACTIVE LED indicates that at least one Laser Diode output is on
and the LCD graphics shows details of active channels.
Output Connectors
Temperature Controller (TEC) 15-pin female D-sub
Dual Temperature Controller (TEC) Two 15-pin female D-sub
Laser Diode Driver (LDD) 9-pin female D-sub, BNC (external Modulation), BNC (auxiliary photodiode input)
Dual Laser Diode Driver Two 9-pin female D-sub
MOPA Laser Diode Driver 15-pin high density female D-sub , 9-pin male D-sub
Combination LDD/TEC 9-pin female D-sub (LDD), and 15-pin female D-sub (TEC)
Chassis Ground 4 mm Banana Jack
GPIB Connector 24 pin IEEE-488
RS232 Connector One 9-pin male D-sub
Power Requirements 90 to 132 volts, 5 Amp Max.; 198 to 250 volts, 2.5 Amps Max. (user selectable),
50 to 60 Hz
Size (H x W x D) 133 mm x 426 mm x 356 mm (5.25 " x 16.75" x 14")
Mainframe Weight 14.3 kg (31.5 lbs.)
Modules Weight 1.1 kg (2.5 lbs.), typical weight each
Operating Temperature 0 to 40°C, < 70% relative humidity non-condensing
Storage Temperature -20°C to 60°C, < 90% relative humidity non-condensing
Laser Safety Features Laser Enable Key switch, Interlock, Output Delay (meets CDRH US21 CFR
1040.10). Interlock and output delay are part of the Laser Module.
Isolation All modules electrically isolated with respect to each other and from earth ground.
In accordance with ongoing efforts to continuously improve our products, Newport
Corporation reserves the right to modify product specifications without notice and
without liability for such changes.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
