Chapter 2 System Operation 15
Figure 5 - Master Display, Condensed Mode
The Master Display can be accessed from any screen in the system by pressing
MASTER
. For slots not containing a module, the text “Not installed” is displayed
next to the slot number.
2.4.5 Main Menu
The Main Menu is shown in
Figure 6
. This is the second highest menu and is used
to access four general system functions:
1.
Modules
- Pressing the adjacent soft key gives access to
each of the four "slot" positions for setup and control of
each module.
2.
Config
- Pressing the adjacent soft key gives access to the
general configuration menu, with soft keys to access
system configure, save/recall, and linking screens.
3.
Comm
- Pressing the adjacent soft key gives access to the
GPIB and RS232 parameters.
4.
Local
- When the unit is in remote mode, either through
GPIB or RS-232C communications, the
Local
soft key
will be available. Pressing it returns the 8000 to a local
state. When in local mode, this key does
not
appear on the
display. The 8000 is placed in remote mode through GPIB
or RS232 communication, or during the execution of a
macro or special function.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
