Newport 8000 - Function Keys; Figure 2 - Various Data Fields Found on the Master Screen

12 Chapter 2 System Operation
data fields above, certain soft keys are programmed to enter a read-only mode when
the unit enters remote mode. Read only soft keys are displayed as an outline rather
than a solid block.
Figure 2 - Various Data Fields Found on the Master Screen
2.4.2 Function Keys
The
FUNC
button serves two purposes on the 8000: first, as a quick navigation
method that speeds switching between module screens; and second, as a method of
setting up and executing user defined macros and special functions.
For macros and special functions, the
FUNC
key is used both to execute and to enter
the setup screen on the particular function. For example, if the 8000 supported a
special function 1, to enter the setup screen of function 1, press
and hold
the
FUNC
key, then press the
1
key, then release both. This would enter the setup screen for
function 1. To execute function 1, press
and release
the
FUNC
key, then press and
release the
1
key. If functions are not setup/supported for a particular key, the 8000
will beep.
Static Field
Non-editable
data field
F
ocused editable
data field
Soft key
Non-focused
editable data field
{
Combo,
Dual
TEC
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com