XPS-D Controller User Interface Manual
2.18 Front Panel – Cycle
The cycle page allows cycling of a stage. A cycle motion moves back and forth between
two defined positions where speed, acceleration and jerk time can be modified during
motion (but not during the acceleration period).
2.19 Front Panel – Jog
The Jog page allows executing a jog motion. A jog motion is a continuous motion,
where only the speed and acceleration are defined, but no target position. Speed and
acceleration can be changed during the motion (but not during the acceleration period).
For a Jog motion, the jog mode must be enabled: click on the “Action” button to
Initialize, Home and then Enable Jog.
EDH0405En1012 – 09/18 18
To Next Page
Loading...
