XPS-D Controller User Interface Manual
2.20 Front Panel – Spindle
The Spindle page provides similar functions to the Jog page. However, specific jog
actions are replaced by spindle actions that only work for Spindle groups.
NOTE
Spindle configuration does not allow indexing of the rotary stage. For a rotary
stage to have indexing and move more than 360 degrees, the user must configure
the stage as a group type other than spindle and change the software travel limits,
MinimumTargetPosition and MaximumTargetPosition, in the stages.ini file. Refer
to section 2.14: “Stage – Add, Remove or Edit Stages
” for more details.
Additionally, the rotary may need to have optical travel limits disabled. Refer to
the rotary stage User's Manual.
19 EDH0405En1012 – 09/18
To Next Page
Loading...
