XPS-D Controller User Interface Manual
Step 3:
To add another parameter, click “ADD BLOCK”.
Repeat Step 1 and Step 2.
3. When all arguments are defined, click “OK”. Now review the final syntax of the
function and make final text changes, as needed. When done, click “Execute”.
4. When the function is executed, the controller’s response code will appear in the
Received message window and a description will appear below the Received message
window. If the command was carried out successfully, 0 is returned. In all other
cases, there will be an error code. Use the function ErrorStringGet() to get the error
code description.
23 EDH0405En1012 – 09/18
To Next Page
Loading...
