XPS-D Controller User Interface Manual
Step 1: Configuration name
1. Enter a name for the Gathering Configuration. Example: Stage_Position.
Step2: When to start
This step configures the data collection trigger and is based upon the API function
EventExtendedConfigurationTriggerSet([Actor].[Category].Event Name, Parameter1,
Parameter2, Parameter3, Parameter4). For more information regarding this API, refer to
Features Manual. If this section is not empty, delete example event trigger by clicking
REMOVE.
1. Click on ADD TRIGGER and the following window appears.
2. From the list, highlight the group name, positioner name, TimerX or GPIO that
triggers when to start collecting data and then click ADD. If the trigger selection is
Immediately or Always, click OK and skip down to Step 3: What to Collect.
25 EDH0405En1012 – 09/18
To Next Page
Loading...
