USB-Link™ 3 Installation and Setup Manual
Chapter 3: Installing the Drivers and Setting Up the Device 28
Making a Wired USB Connection
To connect the USB-Link™ 3 to your PC using a USB cable:
1 Connect the USB cable (i.e., an automotive A to Mini-B USB cable) to the USB port of the PC or laptop.
2 Connect the other end of the cable to the port on the bottom of the USB-Link™ 3.
3 Connect the DB26 female end of the appropriate adapter cable to the USB-Link™ 3.
4 Attach the other end of the adapter cable (i.e., Deutsch connector) to the vehicle’s diagnostic connector.
5 Proceed to Step 3: Test the Connection (pg. 36).
NOTE: The vehicle’s diagnostic connector is typically located under the dashboard on the driver’s side,
or beside the driver’s seat. It can also be located in the engine compartment near the electronic control
module (ECM).
To Next Page
Loading...