USB-Link™ 3 Installation and Setup Manual
Chapter 3: Installing the Drivers and Setting Up the Device 46
The Tools Menu
The Tools menu provides the following features:
• Ping
• Options
Ping
The Ping feature uses the PING command to check for the presence of a device on the network.
To check for a device:
1 Select Tools from the USB-Link™ 3 Explorer menu bar.
2 Select Ping.
3 Enter the IP address of the device you want to locate (e.g., 192.168.123.103).
4 Click Start.
The USB-Link™ 3 Explorer searches for the device and, if found, displays the reply.
5 Click Stop.
6 Click the Close button on the dialog box.
Figure 3.23 Ping Dialog Box
To Next Page
Loading...
