USB-Link™ 3 Installation and Setup Manual
Chapter 3: Installing the Drivers and Setting Up the Device 36
Step 3: Test the Connection
Use the Device Tester to test the connection between the USB-Link™ 3 and the vehicle. At startup,
the Device Tester checks for any USB-Link™ 3 drivers installed on the PC.
To test the connection between the USB-Link™ 3 and the vehicle:
1 Click Start and then select All Programs > NEXIQ > Device Tester.
The application is started and the Device Tester screen is displayed.
2 Use the button in the Driver box to select the appropriate driver (i.e., USB-Link™ 3).
3 Use the button in the Device box to select the appropriate device (for example, USB-Link™ 3, Bluetooth
®
).
- The Device box lists all the devices supported by the USB-Link™ 3 drivers installed on the PC.
Figure 3.15 Device Tester: Status Not Connected
To Next Page
Loading...