NEXIQ Technologies USB-Link 3 Wireless - Step 2: Connect the USB-Link 3 to a Vehicle

USB-Link™ 3 Installation and Setup Manual
Chapter 3: Installing the Drivers and Setting Up the Device 27
Step 2: Connect the USB-Link™ 3 to a Vehicle
Once you have installed the USB-Link™ 3 drivers, you are ready to connect the USB-Link™ 3
to a vehicle using an adapter cable. The following adapters are included in the USB-Link™ 3 kit:
• 9-pin Deutsch Adapter, 1 Meter
• 16-pin, J1962 OBD II Adapter, 1 Meter
Connect the USB-Link™ 3 to your PC using one of the following options:
• A wired, USB connection (pg. 28)
• A wireless, Bluetooth
®
connection (pg. 29)*
• A wireless Wi-Fi connection (pg. 32)*
- Mini Access Point Mode (pg. 32)
or
- Infrastructure Mode (pg. 35)
*Wireless Edition only