GEO M10 HARDWARE SETUP PROCEDURE Page 55/79
- If required, position VNT-EXBARM10 frontwards or rearwards into NT-BUMPM10 slots and lock
devices with the quick release pins 12x40 stored on VNT-BUMPM10.
IMPORTANT
Ensure hoist hook(s) is (are) properly secured to VNT-BUMPM10 or VNT-EXBARM10
shackle(s)
Ensure that all quick release pins are locked
- Insert shackle(s) in bumper or in extension bar in required hole(s), ie:
o If using 1 hoist on VNT-EXBARM10, it must be connected to a hole position determined in
NS1 design
o If using 2 hoists on VNT-EXBARM10, connect these using extreme holes (“A” and “Q”)
o VNT-BUMPM10 without extension bar can only be flown with 2 hoists from front and rear
rigging points
- Connect hoist hook(s) to shackle(s) and lift assembly to sufficient height in order to connect a second
MSUB15;
- Release first MSUB15 bottom connecting points latches and unlock second MS15SUB top front and
rear rigging points
- Align both MSUB15s rigging points, lower second MSUB15 on first and lock them together
- Connect subsequent MSUB15 subwoofers by unlocking upper points and setting lower points in
auto-lock mode.
To Next Page
Loading...
