122
Road Safety Camera
A special Place of Interest type for speed cameras and red light
cameras. Different data sources are available. You can
configure the software to warn you when you approach one of
these cameras.
Detecting the location of Road Safety Cameras is prohibited in
certain countries. It is the sole responsibility of the driver to
check whether this feature can be used during the trip.
Route
A sequence of route events, i.e. maneuvers (for example, turns
and traffic circles) to reach the destination. The route contains
one start point and one destination. The start point is the
current (or last known) position by default. If you need to see a
future route, the start point can be replaced with any other given
point.
Track-up map orientation
In Track-up mode the map is rotated so its top always points in
the current driving direction. This is the default orientation in 3D
map view mode. See also: North-up map orientation.
Vehimarker
The current position is shown with a blue arrowarrow on the
map by default. The direction of the blue arrow shows the
current heading. This position marker can be replaced with
different vehicle and pedestrian symbols. You can even specify
different Vehimarkers for different route types (depending on
which vehicle type is selected for route calculation).
To Next Page
Loading...
Need help?
General
