07
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This appliance and its antenna must not be co-located or operated conjunction with any
other antenna or transmitter.
- A minimum separation distance of 20cm must be maintained between the antenna and the
person for this appliance to satisfy the RF exposure requirements.
FCC CAUTION:
This product does not contain any user-serviceable parts. Repairs should only be made by an
authorised Nextbase™ service centre. Unauthorized repairs or modifications could result in
permanent damage to the equipment, and void your warranty and your authority to operate this device
under Part 15 regulations.
FCC Identifier
The FCC Identifier (FCC ID) is available as an E-label within your Dash Cam’s System Info pages.
To view the FCC ID please follow the steps below:
Note:
- The Regulatory Information (inc. the FCC ID) is embedded with the Dash Cam’s firmware, applied to
the gift box and included within this User Manual.
- The FCC ID cannot be changed by the user.
Press the ‘Menu’ button to enter
the Dash Cam’s menu system.
Connect Apps
Press the ‘Setup’ button.
Swipe through the menu pages
and select System Info.
System Info
622GW
Rxx.x
123456789
2AOT9-NBDVR622GW
Charging
Model:
Firmware:
Serial No:
FCC ID:
Battery Status:
The FCC Identifier (FCC ID) is
seen as above.
Step 3:
Step 1: Step 2:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
