These important safeguard messages will help ensure your enjoyment and proper
use of the HD-STB and accessories. Please read them carefully before you begin
to operate your HD-STB product.
1. Read and Retain this User's Guide
This User's Guide should be read before the HD-STB is operated and retained for
future reference.
2. Use Correct Power
This HD-STB should be operated only from the type of power source indicated on
the rear panel.
3. HD-STB Installation
Do not place HD-STB on an unstable trolly, stand, tripod, bracket, or table as it
may fall, causing serious injury to a child or adult and damage the HD-STB.
4. Provide Antenna Ground
If an outside antenna or cable system is connected to the HD-STB, be sure the
antenna or cable system is grounded to provide some protection against
voltage surges and built-up static charges. An outside antenna system should
not be located in the vicinity or overhead power lines, or other power circuits,
where it can fall onto such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep from touching or
approaching such power lines or circuits as contact with them might be fatal.
Installing an outdoor antenna can be hazardous and should be left to a
professional antenna installer.
5. Provide Proper Ventilation
Opening slots in the STB cabinet are provided for ventilation to ensure reliable
STB operation and to protect it from overheating. HD-STB should not be located
in an enclosed / built-in installation such as a bookcase unless proper
Ventilation is provided.
For sufficient ventilation, there must be at least 10cm free air space above,
behind, top and on each side of the HD-STB.
6. Keep Away from Heat
Do not expose the HD-STB to direct sunlight. This product should be situated
away from heat sources such as radiators, heat registers, stoves and other
electronic products (including amplifiers) that produce heat.
Important Safeguards
To Next Page
Loading...