5
2 NVR Startup
2.1 System Initialization
After connecting the device to the display, plug in the mouse, power
cable and turn on the power switch on the rear panel, then start up the NVR.
The system initialization interface is as shown in Figure 2-1.
Figure 2-1
Notes: The insert figures in this user manual may not be the same as
what you see on display. All figures here are just for reference.
2.2 Boot wizard
After device successfully booted up, it goes to startup wizard, see
Figure 2-2. Click Cancel/Next button, you can see system goes to login
interface, see Figure 2-3.
To Next Page
Loading...