Nibe VVM 320 - Page 27

Logging
Standard parameters
The following parameters are logged as standard in a
VVM 320:
VVM 320:
■
Date
■
Time
■
Version
■
Current operating mode prioritisation
■
BT1 Outdoor temp
■
Average value outdoor temp.
■
EB15-BT2 Heating medium supply
■
EB15-BT3 Heating medium return
■
EB15-BT63 Heating medium after immersion heater
■
EB15-BT6 HW charging
■
EB15-BT7 HW charging, top
■
Calculated supply
■
Actual value of Degree minutes
■
Status GP1
■
Speed GP1
■
Status GP6
■
Alarm
■
Relay status of base card (AA2)
■
Power step number
Heat pump:
■
EB10X-BT12 Condenser out
■
EB10X-BT3 Return
■
EB10X-BT14 Hot gas
■
EB10X-BT17 Suction gas
■
EB10X-BT16 Evaporation
■
EB10X-BT15 Fluid pipe
■
EB10X-BT28 Outdoor temperature
If F2040 is connected:
■
EB 10X-BP4 Pressure transmitter
■
Low pressure transmitter located in the MHI part
■
Current compressor frequency
■
Calculated compressor frequency
■
Protection mode
And also the following, if connected:
■
EB15-BF1 flow meter
■
BT25 external supply temperature sensor
■
BT50 Room temperature
■
BT51 Pool sensor
TIP
To change which values are logged Nibe Ap-
plications software is required.
NIBE Applications
Nibe Applications software is used to manage settings
files and log files.
Updating software
NIBE supplies updated software and instructions for
upgrading at www.nibe.eu/software.
25Chapter 4 | Description of functionsNIBE™ VVM 320