21
13.3 - QUICK RELEASE OPERATION
The quick release will allow for manual gate operation. Before
disengaging the quick release make sure to disable power
from the control board by unplugging the main and battery
power terminals.
Engaged
Disengaged
Pull and turn to disengage
BATTERY
SOLAR
POWER
MAIN DC
POWER
Disengage the quick release assembly by pulling the handle
until the lock pins seperate from the sprocket and turning in
either direction a half turn.
Note: If the gate or motor is in a bind the chain could be tight
and cause increased pressure on the quick release assembly.
You may not be able to pull the handle until the pressure is
relieved.
Once the quick release is disengaged you can manually move
the gate.
When ready to rengage the quick release simply turn the
handle until the pins seat back into the sprocket and lock into
place.
Quick release
assembly
+ -
Quick release
assembly
To Next Page
Loading...
