Linear Sales
(800) 543-4283
Linear Service
(800) 421-1587
M – F, 8am – 7pm EST
Nice North America LLC
5919 Sea Otter Place, Suite 100
Carlsbad, CA 92010
www.linear-solutions.com
10033066 Rev-X7
Niceforyou.com
©2023 Nice North America LLC. Linear is a registered trademark
of Nice North America LLC. All rights reserved.
REGULATORY INFORMATION
We, Nice North America LLC of 5919 Sea Otter Place, Carlsbad, CA 92008, declare under our sole responsibility that the device, LINEAR600
complies with Part 15 of the FCC rules.
FCC & IC Notice
This device complies with Part 15 of the FCC Rules and Industry Canada license exempt standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference received that may cause undesired operation. Le présent appareil est
conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician to help.
WARNING:
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
To Previous Page
Loading...
Need help?
General
