5
Vacation Lock for Additional Security
a) Press the Wall Station’s LOCK button to prevent remote controls and
keypads from opening the door after the door is completely closed.
They can close the door, but not open it once closed. The door can still
be opened or closed by using the wall station pushbutton or via the
Nice G.O. app.
NOTE: To indicate that the Vacation Lock is enabled, the blue arrows
will ash.
NOTE: If a transmitter is activated in an attempt to open the door
while in vacation mode, the operator will beep and ash ve times.
b) Press the Wall Station’s LOCK button again to unlock and return the
operator to normal operation.
Controlling the Light Panel
a) The Light Panel can be lit by pushing the wall station’s LIGHT button.
The light will remain on until the LIGHT button is pressed again or the
operator is cycled.
b) If the Light Panel is on, pushing the wall station’s LIGHT button will
turn the operator’s light off.
Disconnecting the Door from the Operator
a) With the door in any position (preferably closed), carefully pull the
red release handle. USE CAUTION IF THE DOOR IS OPEN, THE
DOOR MAY DROP. The disconnected door can be opened or closed
manually.
b) To re-connect the operator, ip the release lever up. Raise or lower
the door manually until the operator reconnects.
IF DOOR BECOMES OBSTRUCTED,
PULL DOWN ON HANDLE
NOTICE
IF DOOR BECOMES OBSTRUCTED,
PULL DOWN ON HANDLE
NOTICE
b
a
To Next Page
Loading...
Need help?
General
