Nidec F600 - F600 Control Terminal Connections

19 F600 Step By Step Guide
Control connections
The control terminals are configured by default for the arrangement shown below:
Figure 6-9 F600 control terminal connections
Auto select
Analog outputs may
be used as 10V supply
for 0-10V input.
Main process
PID Feedback
4-20 mA input
Motor protection
input
Digital I/O (Free to assign)
Hand select
Digital I/O (Free to assign)
Analog Hand mode
speed reference
(if required)
0 to 10V input
Relay 1
(240 Vac, installation
over-voltage category II)
Safe Torque Off/
Drive enable
Drive active
Drive Healthy
Unassigned
Relay 2
(240 Vac, installation
over-voltage category II)