NIDO ONE V2 - Other Types of Installation

13
OTHER TYPES OF INSTALLATION
Use a submersible pump for aquariums with
built-in lter (ow rate min. 450 l/h and max.
1200 l/h).
When the use of tank bulkhead ttings is not allowed,
for example, if drilling the water container is not
possible or in case of installations in submerged
tanks, it is necessary to install NIDO ONE V2 with a
submersible pump.
1� Connect the submersible pump to the IN pipe of
the NIDO ONE V2.
2� Connect the OUT pipe of the NIDO ONE V2 to the
tank.
3� Connect the submersible pump to the NIDO
connector.
4� Congure the NIDO plug as a “ow pump” via the
NidoPro app.
(Settings > Devices).
INSTALLATION IN SUBMERGED TANKS
INSTALLATION WITH SUBMERSIBLE PUMP