NIDO ONE V2 - Nido One V2 First Start

14
NIDO ONE V2 FIRST START
Ensure that the connection pipes are placed
as low as possible to avoid air pockets in
the circuit.
NIDO ONE V2 will turn the internal pump on and
check the nutrient solution every 15 minutes on a new
system.
NIDO ONE V2 may take 4 to 9 hours to bring the
water to the desired values.
Once the water has reached the target set in the
NidoPro app, NIDO ONE V2 will keep the values
constant, performing 96 checks per day to ensure pH
and EC stability.
If NIDO ONE V2 has problems with water ow at rst
use, loosen the pH probe to remove any air bubbles
from the hydraulic circuit and retighten it after a few
seconds; if the problem persists, repeat the operation
and check the hoses and hydraulic connections.
The fertiliser and pH indicators may light up on
initial start-up; these indicators are not connected
to electronic sensors but are based on proprietary
algorithms that have a good detection tolerance but
not a reliable and absolute accuracy.
Switching on these indicators does not cause any
problem in the operation of NIDO ONE V2.