11Introduction
First Steps
Always turn the camera off before inserting or removing batteries or memory cards.
1 Attach the strap.
Attach the strap as shown. Repeat for the second eyelet.
2 Charge the battery.
If a plug adapter is supplied, raise the wall plug and connect the plug adapter
as shown below at left, making sure the plug is fully inserted.
Insert the battery
and plug the charger in.
An exhausted battery will fully charge in about an hour
and 50 minutes.
D During Charging
Do not move the charger or touch the battery during charging.
Failure to observe this
precaution could in very rare instances result in the charger showing that charging is
complete when the battery is only partially charged.
Remove and reinsert the battery to
begin charging again.
Battery charging
Charging complete
To Next Page
Loading...
