211Connections
Copy Pictures to the Computer
Before proceeding, be sure you have installed ViewNX 2 (0 210).
1 Connect the USB cable.
After turning the camera off and ensuring that a memory
card is inserted, connect the supplied USB cable as shown
and then turn the camera on.
Using ViewNX 2
A Use a Reliable Power Source
To ensure that data transfer is not interrupted, be sure the camera
battery is fully charged.
A Connecting Cables
Be sure the camera is off when connecting or disconnecting
interface cables.
Do not use force or attempt to insert the
connectors at an angle.
D During Transfer
Do not turn the camera off or disconnect the USB cable while
transfer is in progress.
D USB Hubs
Transfer may not proceed as expected if the camera is connected
via a USB hub or keyboard.
To Next Page
Loading...
