X Technical Specifications
51
X
Model for 220, 230, 240 V Areas
• Input voltage: Select from 220 V, 230 V or 240 V AC by relocating
the fuse holder in the AC inlet.
• Frequency: 50/60 Hz
• Voltage fluctuation: ±10％
• Rated current: 0.4 A max.
• Fuse rating: 250 V, 1 A, time-lag low-breaking type, 5x20
miniature fuse x2
• Power cord: Use only the following power supply cord. Using the
wrong power cord could result in danger or fire. The
protection Class I equipment should be connected to
PE (protective earth) terminal.
• Approved according to EU/EN standards, 3
conductor grounding Type H05VV-F, 3 m long
maximum, rated at 250 V AC minimum.
• Protection Class: Class I
(8) Operating Environmental Conditions
• Room Temperature: 0 to 40°C
• Relative Humidity: 85% max., non-condensing
• Altitude: 2000 m max.
• Pollution: Degree 2
• Installation Category
(Overvoltage Category): Category II
• For indoor use only.
(9) Storage and Transport Environmental Conditions
• Temperature: -20 to +60°C
• Humidity: 90%RH max., non-condensing
(10) Conforming Standards
• The model for 100, 110, and 120 V areas is a UL-listed product.
• The model for 220, 230 and 240 V areas meets EU IVD Directive (In vitro diagnostic medical
device directive) requirements.
(GM approved: In vitro diagnostic medical device)
• The model for 220, 230 and 240 V areas meets EU LV Directive (Low voltage directive)
requirements.
• The model for 220, 230 and 240 V areas meets EU EMC Directive requirements. (EN61326)
(The model for 100, 110, and 120 V areas is not covered by the FCC.)
To Previous Page
Loading...
