Nikon K 5 - Page 153

Nikon N Series/K Series Total Station Instruction Manual 135
Menu Key 5
Adding a point name
In the point list, press the
Add softkey to add a new
point name to the current layer.
Enter a new point name and then press
[ENT].
The point name is added to the current layer and the list
is updated.
Adding a code
In the code list, press the
Add softkey to add a new
feature code to the current layer.
Enter the feature code in the CD field. Press
[MODE] to
change between alphabetic and numeric input mode.
You can use the REC field to define a numeric
identifier for each feature code. This is optional: If
there is a value in the REC field, this value is stored. If
you leave the REC field blank, the CD value is stored.
Press
[ENT] to add the new code and update the code list.