3 Getting Started
24 Nikon N Series/K Series Total Station Instruction Manual
Turning the Instrument On and Off
Turning on the instrument
1. To turn on the instrument, press [PWR]. The start-
up screen appears. It shows the current
temperature, pressure, date, and time.
2. To change the temperature or pressure value,
use
[^] or [v] to move the cursor to the field that
you want to change. Then press
[ENT].
3. Tilt the telescope until it passes the horizontal
position on Face-1.
Turning off the instrument
To turn the instrument off, press [PWR] and [ENT].
Then do one of the following:
If you have entered your name or your company’s name in the Owner’s detail
field, the text from this field appears on the start-up screen. To set the Owner’s
detail field, go to MENU > Settings > Other. For more information,
see page 121.
Press ... To ...
[ENT] again turn off the instrument
the Reset softkey reboot the program and re-start the instrument
the
Sleep softkey put the instrument into power-saving mode
[ESC]
cancel the power-off process and return to the previous screen
If you press the Reset softkey, the software is rebooted and the Basic Measurement Screen (BMS) appears
without an open job.
To Next Page
Loading...
