Nikon R1 - Page 44

Procedures for Commander flash operation
44
6
Compose a picture and shoot with flash.
1
Compose the picture and shoot.
Ensure that the red ready-lights on the
SU-800 and SB-R200 are on, then release
the shutter.
• For details on test firing, refer to page 88.
 If the red ready-light blinks immediately after shooting
In TTL mode, when the SB-R200 flash has fired at its maximum
output and underexposure may have occurred, the red ready-
light on the SB-R200 will blink for approx. 3 sec. (The ready-
lights on the SU-800 and in the camera’s viewfinder do not
blink.)
To compensate, move closer to the subject, set a higher ISO
sensitivity or use a wider aperture and reshoot.
ON
READY
LOCK
E
L
SEL
A
B
O
O
N
/O
FF
W
IRE
LE
SS
R
SPEEDLIG
HT
S