Service Manual: SC750, SC800, SC 750 ST, SC800 ST
Form Number 56043150 Page 126
Palm Button Switches – ST models
1. Remove two switch mounng screws.
2. Remove upper handle bolts.
3. Loosen lower handle bolts and rotate handle down.
4. Disconnect handle electrical connector.
5. Remove access plate.
6. Disconnect wiring.
7. Remove switch and wiring.
a. Tip – To make it easier to install a new switch, use a spare piece of wire aached to the wires of
the old switch when you pull it out. Aach the new switch wires to the spare wire to pull the
wiring back through the handle.
8. Reassemble in reverse order.
Reverse Switch – ST models
1. Remove two switch mounng screws.
2. Remove upper handle bolts.
3. Loosen lower handle bolts and rotate handle down.
4. Disconnect handle electrical connector.
5. Remove access plate.
6. From inside the handle area, push the switch out of the handle.
7. Disconnect wiring and remove.
8. Reassemble in reverse order.
To Next Page
Loading...
