10
ATTIX 30-50 H/M
Attach the upper section of 7.
the vacuum cleaner.
Close the retaining clamps 8.
(A). Ensure that the retain-
ing clamps fit properly.
A
B
A
3.3 Insert the safety filter bag
The mains plug should not 1.
yet be inserted into a sock-
et.
Open the retaining clamps 2.
(A) and remove the upper
sectionof the vacuum clean-
er
A
B
A
C
D
Insert the safety filer bag 3.
into the dirt tank
Press the safety bag con-4.
nection firmly into the inlet
fitting.
Check that the ventilation 5.
holes (D) remain inside the
dirt tank.
Fold the top edge of the dis-6.
posal bag over the rim of the
dirt tank.
Before picking up dust with occupational exposure limit values:
Check that all the filters are present and properly fitted1.
The hose diameter and the setting for the suction hose diameter 2.
must be the same.
When the motor is running, hold the suction hose shut. For safety 3.
reasons, an acoustic warning sounds if the air speed in the suction
hose drops to below 20 m/s.
*)
OEL values = Occupational Exposure Limit
Type of dust Filter bag/waste bag/filter element
Dusts with OEL values • > 0.1 mg/
m
3
(observe any additional national
regulations)
Wood dusts & concrete dusts•
Waste bag (5 pcs.)
Order No. 302001310
Dusts with OEL values • > 0.1 mg/
m
3
(observe any additional national
regulations)
Wood dusts & concrete dusts•
Filter bag
ATTIX 30-XM: Order No. 302004000
ATTIX 50-XM: Order No. 302004004
Dusts with OEL values • > 0.1 mg/
m
3
(observe any additional national
regulations)
Wood dusts & concrete dusts•
Filter element “M” PC:
Order No. 302000490
Flat filter element “M” XC:
Order No. 302002842
To Next Page
Loading...
Need help?
General
