2
ATTIX 30-50 H/M
1 Important safety instructions
Symbols used to mark
instructions
Prior to using the appliance for the first time, be sure to read
this document through and keep it ready to hand.
DANGER
Danger that leads directly to serious or irreversible injuries,
or even death.
WARNING
Danger that can lead to serious injuries or even death.
CAUTION
Danger that can lead to minor injuries and damage.
The appliance must
only be used by persons, who have been instructed in its correct •
usage and explicitly commissioned with the task of operating it
only be operated under supervision•
not be used by children•
Before starting work, the operating staff must be informed on
use of the vacuum cleaner•
risks associated with the material to be picked up•
safe disposal of the picked up material•
Do not use any unsafe work techniques.1.
Never use the vacuum cleaner without a filter.2.
Switch off the appliance and disconnect the mains plug in the 3.
following situations:
Prior to cleaning and servicing -
Prior to replacing components -
Prior to changing over the appliance -
If foam develops or liquid emerges -
Besides the operating instructions and the binding accident preven-
tion regulations valid in the country of use, observe recognised regu-
lations for safety and proper use.
Purpose and intended use
Since 1997, there is a new division of hazardous dusts and their as-
signed vacuum machines. These are regulatedby IEC 60335-2-69
(world wide) and by EN 60335-2-69 (European wide)
Dust class H (high). The dusts which belong to this class are:
dusts with OEL values
*)
, all carcinogenic dusts and dusts
which are mixed with pathogenic agents. Vacuums for Dusts
Class H are tested in their entirety and have a maximum degree of
permeability of 0.005%, The disposal must be dust free.
Dust class M (medium). The dusts which belong to this class
are: dusts with OEL values
*)
> 0.1 mg/m
3
as well as sawdust.
The machine is tested in its entirety by vacuums for this dust
class. The maximum degree of permeability is 0.1% and the dis-
posal must be low dust
The air flow in Safety Vacuum systems has to be strictly controlled to
achieve a minimum flow rate of Vmon = 20 m/s in the suction hose.
*) OEL values = Occupational Exposure Limit
To Next Page
Loading...
Need help?
General
