17
ATTIX 30-50 H/M
7 Maintenance
7.1 Maintenance plan
After finishing work When required
7.2.1 Emptying dirt tank
7.2.2 Replacing the safety filter bag
7.2.3 Replacing the filter bag
7.2.4 Replacing the disposal bag
7.2.5 Replacing filter element (H) (Push&Clean)
7.2.6 Replacing filter element (H) (XtremeClean)
7.2.7 Replacing filter element (M) (Push&Clean)
7.2.8 Replacing filter element (M)(XtremeClean)
7.2 Maintenance work
7.2.1 Emptying the dirt tank
After emptying the tank: clean the
rim of the tank and the seals in the
intermediate ring and the upper sec-
tion of cleaner before refitting them.
If the seal or groove is dirty or dam-
aged, the suction performance will
be reduced.
Before reinserting the suction hose:
clean the inlet fitting and hose col-
lar.
Switch off the vacuum clean-1.
er and pull the mains plug
out of the socket.
Open the retaining clamps (A) 2.
and remove the upper sec-
tion of the vacuum cleaner.
Tip out the collected dirt.4.
Dispose of the dirt in accord-5.
ance with legal regulations.
Attach the upper section of 6.
the vacuum cleaner.
Close the retaining clamps 7.
(B). Ensure that the retaining
clamps fit properly.
A
A
A
A
To Next Page
Loading...
Need help?
General
