Nilfisk-ALTO ATTIX 30 User Manual

23
ATTIX 30-50 H/M
A
A
7.2.7 Replacing filter element
(M) (Push & Clean
System)
Never use the vacuum clean er with-
out a filter.
Switch off the vacuum 1.
cleaner and pull the mains
plug out of the socket.
Open the retaining clamps 2.
(A) and remove the up-
per section of the vacuum
cleaner.
Removing the filter element:
Turn the filter holder anticlo-3.
ckwise and remove it .
Carefully remove the filter 4.
element.
Clean the filter seal (B). 5.
Check it for damage and re-
place it if necessary.
Inserting the filter element:
Fit the filter holder and turn 6.
it clockwise to secure it.
Dispose of the used fi l-7.
ter element in accord-
ance with legal regulations.
Attach the upper section of 8.
the vacuum cleaner.
Close the retaining clamps 9.
(A). Ensure that the retain-
ing clamps fit properly.
A
A
A
A
B
Attach the upper section of 11.
the vacuum cleaner.
Close the retaining clamps 12.
(A). Ensure that the retaining
clamps fit properly.

Nilfisk-ALTO ATTIX 30 Specifications

General

Category	Vacuum Cleaner
Tank Capacity	30 l
Airflow	3700 l/min
Vacuum Pressure	250 mbar
Hose Length	2.5 m
Dimensions	450 x 380 x 595 mm
Model	ATTIX 30
Mains connection	230 V, 50-60 Hz
Cable Length	7.5 m