EasyManuals Logo

Nilfisk-ALTO ATTIX 30 User Manual

Nilfisk-ALTO ATTIX 30
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
3
ATTIX 30-50 H/M
The vacuum cleaners are suitable to pick up
dry, nonflammable dust, non flammable liquids, sawdust and
hazadous dusts with OEL values
*)
, carcinogenic dusts, dusts
containing germs.
The vacuum cleaners ATTIX 30-XH and ATTIX 50-XH are also ap-
proved for asbestos abatement (TRGS 519).
The vacuum cleaners are suitable for commercial use, such as e.g.
in
Hotels, Schools, Hospitals, Factories, Shops, Offices, Hire
shops
Any other use is considered as improper use. The manufacturer ac-
cepts no liability for any damage resulting for such use. The risk for
such use is borne solely by the user.
Proper use also includes proper operation, servicing and repairs as
specified by the manufacturer. See operating instructions.
Transport
Before transporting the dirt tank, close all the locks.1.
Do not tilt the cleaner if there is liquid in the dirt tank.2.
Do not use a crane hook to lift the cleaner.3.
Storage
Store the appliance in a dry place, protected from frost.1.
Maintenance, cleaning and
repair
During the following work, ensure that dust is not unnecessarily
spread around. Wear a P2 bresthing mask.
CAUTION: In the case of asbestos abatement wear additional sin-
gle-use clothing.
Only carry out maintenance work described in the operating in-
structins.
Always pull the out the mains plug before cleaning and maintenance
of the vacuum cleaner.
During maintenance and cleaning, handle the vacuum cleaner in
such a manner that there is no danger for maintenance staff or other
persons.
In the maintenance area
Use filtered compulsory ventilation1.
Wear protective clothing2.
Clean the maintenance area so that no harmful substances get 3.
into the surroundings.
Electrical connection
It is recommended that the vacuum cleaner should be connected 1.
via a residual current circuit breaker.
Arrange the electrical parts (sockets, plugs and couplings) and 2.
lay down the extension lead so that the protection class is main-
tained.
Connectors and couplings of power supply cords and extension 3.
leads must be watertight.
Extension lead
As an extension lead, only use the version specified by the man-1.
ufacturer or one of a higher quality. See operating instructions.
When using an extension lead, check the minimum cross-sec-2.
tions of the cable:
Cable length Cross section
< 16 A < 25 A
up to 20 m 1.5 mm
2
2.5 mm
2
20 to 50 m 2.5 mm
2
4.0 mm
2
*) OEL values = Occupational Exposure Limit

Other manuals for Nilfisk-ALTO ATTIX 30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-ALTO ATTIX 30 and is the answer not in the manual?

Nilfisk-ALTO ATTIX 30 Specifications

General IconGeneral
CategoryVacuum Cleaner
Tank Capacity30 l
Airflow3700 l/min
Vacuum Pressure250 mbar
Hose Length2.5 m
Dimensions450 x 380 x 595 mm
ModelATTIX 30
Mains connection230 V, 50-60 Hz
Cable Length7.5 m

Related product manuals