5-1
I4-1
OPERATOR’S MANUAL FOR INFANT INCUBATOR EDITION/REVISION B/0
SECTION 5
CLEANING AND MAINTENANCE
5.1 GENERAL
This section provides cleaning and maintenance instructions.
WARNING
1. Disconnect all the connections with oxygen feeding device before cleaning and
maintenance. Cleaning or maintenance in the invironment full with oxygen will
cause fire or explosion.
2. The incubator with cabinet adopts the connector of power cord as the isolation mains
power supply, therefore, to make sure the safety, and pull off all powre cords before
cleaning.
5.2 CLEANING
This device must be cleaned and sterilized for the first time for initial use, or after used it for
one week.
5.2.1 DISASSEMBLY BEFORE CLEANING
A. Remove The Controller
Disconnect the Power Cord and Sensors from the side of the Incubator.Release the latch on
each side of the Controller as shown in Figure 5.1 to take out the controller.
Spanner
WARNING: The controller can be taken out from the incubator, when the Spanner pull
out to >90° direction.
WARNING: The Controller heater can be sufficiently hot to cause burns; avoid
removing the Controller or touching the heater until the unit has
been switched
FIGURE 5.1
To Next Page
Loading...
